Leeson Micro Series Compact Inverters Manual de usuario Pagina 62

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 92
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 61
22 TORQUE (TORQUECURVESELECTION)
ThisparameterisusedtoselectwhethertheoutputofthedrivefollowsaconstantorvariableV/Hzcurve.
The following selections are available:
CONSTANT Useforconstanttorqueapplicationstooptimizetorque.
VARIABLE Useforvariabletorqueapplicationstooptimizeenergysavings.
CT/NOCMP Useforconstanttorqueapplicationsthatrequirefulloverloadcapacityatlowspeeds
(seeParameter17-MOTOROL).
23 CARRIER (CARRIERFREQUENCY)
Thisparametersetsthecarrierfrequency,orswitchingfrequencyoftheoutputIGBT’s.Higherswitching
rates result in less audible noise to be emitted from the motor, but the efficiency of the drive decreases as
the carrierfrequencyincreases.Therefore, this parameter should be settothelowest value which yields
acceptablesoundlevels.Availablesettingsare:2.5kHz,6.0kHz,8kHz,10kHz,12kHzand14kHz.
NOTE 1:The2.5kHzcarrierfrequencysettingisavariablecarrier.Thecarrierfrequencyremainsfixedat
1.5kHzupto25Hzoutputfrequency.Above25Hz,thecarrierisafixedmultipleof60timesthedrive’s
outputfrequency.Forexample,iftheoutputfrequencyofthedrivewassetto45Hz,thecarrierfrequency
wouldbe2.7kHz(45Hzx60=2700Hz).
NOTE 2:Theability tooperate adriveinthequiet (highcarrier frequency)modeisdependentonthe
drive horsepower rating, driven load, drive enclosure, and the ambient temperature. At full ambient tem-
perature,operationabove8kHzrequiresderatingthedrivebymultiplyingtheoutputcurrentratingbythe
followingfactors:0.94at10kHz,0.89at12kHz,and0.83at14kHz.
NOTE 3:IfthedriveisequippedwiththeHighOutputFrequencyoption,andMAXFRQissetabove120
Hz,CARRIERwillautomaticallychangeto14kHz,andtheCARRIERparameterwilldisappearfromthe
parameter menu. Operation at 14 kHz carrier frequency requires derating as shown in NOTE 2 above.
60
Vista de pagina 61
1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 91 92

Comentarios a estos manuales

Sin comentarios