RUN/JOG switch
Using a RUN/JOG switch is recommended in applications
where quick stopping is not needed and frequent jogging is
required. Use a single-pole, two-position switch for the
RUN/JOG switch, and a single-pole, normally open,
momentary operated pushbutton for the JOG pushbutton.
Connect the RUN/JOG switch and JOG pushbutton to
terminal board TB501 as shown in Figure 18 below. The
motor stops when the RUN/JOG switch is set to JOG.
Press the JOG pushbutton to jog the motor. Return the
RUN/JOG switch to RUN for normal operation.
Figure 18. RUN/JOG Switch
Comentarios a estos manuales